Garage door springs are the essential components for automatic garage doors, as they are responsible for lifting and lowering the garage door by handling its overall weight. However, automatic garage doors are operated by an electric opener, but it is not a garage door opener that does actually lift the garage door effortlessly, it is the springs that do this job. If you don’t have enough information about garage door springs, don’t be afraid to call Harold’s Garage Door Repair Service. They always have someone by the phone to answer your queries that you have. They always offer emergency garage door repair services.
Determine the weight of the garage door:
To understand the importance of garage door springs, let’s consider the actual weight of the garage door. Definitely, garage door weight varies based on the material used, size, operating system, and insulation. A standard garage door weight may start from 100 to 150 pounds, medium garage door weights between 200 to 300 pounds, while large commercial garage doors can range more than 400 pounds. To support the weight of garage doors, the springs need to be strong, sturdy, and enduring.
However, with the passage of time, due to continued usage, general wear and tear can happen and the garage door spring eventually breaks which needs to be replaced. Dealing with the broken garage door springs can be extremely dangerous; this is why it is strongly recommended to consult an expert to do it. When you are in need of buying new garage door parts, especially the springs, it is advisable to choose high-quality items, even though they may be a little costly than the average products. It is a wise action to take for security reasons, but also this way you can actually save a lot of money and effort in a long run. If you replace broken garage door springs with low-quality products, they are likely to break quickly and you will be forced to hire another service and buy a new spring again.
Torsion and extension garage door springs:
Automatic garage doors come with two types of springs. One is a torsion spring and the other is an extension spring. There are different models of springs based on the type and model of the garage door. Garage door torsion springs are placed above the top of the garage door and they are likely to break quickly because they are used to support the weight of the garage door during the opening and closing process. They are normally made of galvanized metal.
The endurance of torsion springs is determined by the length of springs, the size of wire used in the springs, and the internal diameter. Most garage doors are installed with a set of torsion springs which are located right above the garage door opening. If one spring breaks then another one can support the operations of the garage door and preventing potential harm and damages. On the other hand, extension springs are located on both sides of the garage door, right above the tracks towards the upper panel of a garage door. Their responsibility is to stretch when the garage door opens or closes.
The life cycle of garage door springs:
Both extension and torsion springs have a specific life cycle describe by the manufacturer. On average both springs are expected to have about 10,000 operating cycles that is five to seven years. It means that you should be able to open and close the garage door approximately 10,000 times before they are worn out. By understanding the basic information about garage door springs, you will find it easier to keep your garage door in a good working position.